Owners manual

23
RESERVOIR RESEAL - DISASSEMBLY
STEP 9
Turn reservoir right-side up and lightly clamp in vise. Using the rubber mallet handle, begin tapping the dividing piston
down. This will remove the Schrader
TM
valve end cap and the dividing piston from the reservoir.
If the rubber mallet handle is not long enough, use a piece of PVC pipe that is the correct length.
IMPORTANT!
As you tap the parts down, make sure to catch the Schrader
TM
valve end cap and the dividing piston from the
opposite end of the reservoir so they do not fall onto the ground.
!
STEP 10
Remove o-ring from Schrader
TM
end cap using pick.
STEP 11
60mm - Remove o-ring from dividing piston using pick.
46mm - New dividing piston comes complete. Discard and
replace with new part. Continue to Step 13.