Owners manual

14
ROD GUIDE
RESEAL.
STEP 1
Clamp rod end in vise.
STEP 2
Remove rod nut using 3/4” socket or open-end wrench.
Use a buering layer between the clamp and eyelet,
such as a towel, to avoid scratching the rod-end.
Before starting, you must determine if you have a 60mm or 46mm shock (refer to section: How to Measure
Your Shock Absorber, page 4) and purchase the appropriate seal kit. Seal kits include all rod guide seals and
reservoir components (shown on page 11).
60mm Seal Kit: Part# B4-KT0-Z024A01
46mm Seal Kit: Part# B4-KT0-Z023A01
60mm Rod Guide Seals
46mm Rod Guide Seals