Owners manual

E4-WM5-Y381A00
MOUNTING INSTRUCTION
created: 06.18.10 E4-WM5-Y381A00_0 page 3 of 4 latest revision:
Front Reservoir Bracket Installation Procedure:
A. The reservoir brackets are recommended to be installed on the outer frame rail, just above the sway bar
bushings. Each front shock includes a bracket kit.
B. Each bracket kit includes two ¼”-20 screws and two split washers. The frame rail must be drilled and
tapped in order to install the screws.
Figures 2 & 3 depict the recommended bracket position. The driver side is shown.
C. It is recommended to hold the reservoir up to the frame rail in the appropriate position and mark or scribe
lines on the frame rail on either side of the reservoir. Then center the bracket between the lines and mark
the bolt hole centers with a centerpunch or marker.
Figure 2
Figure 3