Owners manual

E4
E4E4
E4
-
--
-
WM5
WM5WM5
WM5
-
--
-
Y
YY
Y
4
44
4
92
9292
92
A0
A0A0
A0
0
00
0
MOUNTING I
MOUNTING IMOUNTING I
MOUNTING I
N
NN
N
STRUCTION
STRUCTION STRUCTION
STRUCTION
Created on 07.09.15 E4-WM5-Y492A00_0 page 3 of 3
1. Reinstall OEM spring seat on supplied spring seat adaptor, Bilstein supplied bump stop
cap, OEM coil spring, and all OEM upper mount parts including bump stop, and upper
spring hat in their original positions. Install new flange nut (supplied) on the shock
absorber top mount pin and tighten to 25 Nm (19 lb/ft).
2. Install new Bilstein supplied flange nuts on the lower T-Bar mount and tighten to 25 Nm (19
lb/ft). Do not re-use original lock nuts.
3. Check and adjust vehicle front-end alignment after installation.
Supplied flange nut
OEM spring seat
C
irclip
Piston rod snap ring
Supplied spring seat adaptor
Supplied flange nuts
Supplied bump stop cap