Owners manual

E4
E4E4
E4
-
--
-
WM5
WM5WM5
WM5
-
--
-
Y
YY
Y
547
547547
547
A
AA
A
0
00
0
0
00
0
MOUNTING I
MOUNTING IMOUNTING I
MOUNTING I
N
NN
N
STRUCTION
STRUCTION STRUCTION
STRUCTION
created: 10.14.2015 E4-WM5-Y547A00_0 Page 2 of 5 latest revision:
A. Remove the shock and spring unit from the vehicle following all procedures in the vehicle
manufacturer’s service manual. Note the position of the studs in the upper mount relative to
the lower mount bearing (important for reassembly).
B. Using an appropriate spring compressor, compress the coil spring until it can be rotated
freely by hand. Then disassemble the shock and spring unit.
C. Refer to Figure 1 to identify which original parts must be re-used.
Parts supplied by Bilstein:
1. M12 Washer (x1)
2. M12x1.5 Locknut (x1)
3. Spring seat support (x1)
4. M12x1.75 Flange nut (x2)
5. M12x1.75 Bolt (x2)
Original parts to be reused:
6. Upper mount (with isolator and dust cover)
7. Bump stop
8. Coil spring
9. Spring seat
Figure 1
2
3
4
5
6
7
8
9
(Not to Scale)
1