Owners manual

E4-WM5-Y406A00
MOUNTING INSTRUCTION
Created on: 02/15/2012 E4-WM5-Y406A00_0 page 2 of 2 revised on:
1. Remove the existing front shocks from the vehicle following all procedures in the vehicle manufacturer’s
service manual.
2. Install the new Bilstein shock absorber in the original location and slide the upper mount studs into place.
Thread the supplied nuts on loosely.
3. Install the lower mount.
4. Torque the upper mount nuts to 45 N•m (33 lb•ft).
5. If a chassis hoist has been used, be sure to lower the vehicle such that its full weight is on the
suspension prior to fully tightening the lower fasteners.
6. Tighten the lower mount fasteners to the vehicle manufacturer’s service manual torque specification.
Vehicle Frame
Self-locking Nuts
Washers