Owners manual

E4-WM5-Y344A00
MOUNTINGINSTRUCTION

created on 03.06.08 E4-WM5-Y344A00_1 page 3 of 3 revised on: 21.04.09
1. Reinstall OEM spring seat on supplied spring seat adaptor, Bilstein supplied bump stop cap,
OEM coil spring, and all OEM upper mount parts including bump stop, and upper spring hat in
their original positions. Install new flange nut (supplied) on the shock absorber top mount pin
and tighten to 25 Nm (19 lb/ft).
2. Install new Bilstein supplied flange nuts on the lower T-Bar mount and tighten to 25 Nm (19
lb/ft). Do not re-use original lock nuts.
3. Check and adjust vehicle front-end alignment after installation.
supplied
flange nut
supplied spring seat
adaptor
OEM spring seat
supplied bump stop
cap
supplied
flange nuts
circlip