Owners manual

E4-WM5-Y362A00
MOUNTI
created: 08.05.09 E4-WM5-Y362A00_0 Page 4 of 5 latest revision:
NG INSTRUCTION
Refer to Figure 3 for steps E through I.
E. Install the spring seat support (4) on to the shock body (with the smaller end up) such that the
groove inside the spring seat support fits over the circlip on the shock body. Install the spring
seat support in the direction shown only. The circlip must fit completely in the groove inside
spring seat support (see detail). Improper installation will cause permanent damage to the
shock!
F. Install the original spring seat (8) on to the shock and over the spring seat support (4) in the
direction shown only.
G. Install the rubber sleeve (3) over the piston rod. Push it on to the chromed part of piston rod
(see detail).
H. Install the bump stop (6) over the piston rod.
I. Install the steel spacer (2) over the piston rod, above the rubber sleeve. sleeve.
Figure 3
detail
detail
2
3
6
8
4