Owners manual

E4
E4E4
E4
-
--
-
WM5
WM5WM5
WM5
-
--
-
Y3
Y3Y3
Y3
38
3838
38
A00
A00A00
A00
MOUNTING I
MOUNTING IMOUNTING I
MOUNTING I
N
NN
N
STRUCTION
STRUCTION STRUCTION
STRUCTION
erstellt am: 06.12.07 E4-WM5-Y338A00_1 Page 2 of 2 zuletzt geändert am: 27.08.15
4. Install bellows boot on shock absorber
• Position lower end of bellows 240mm ± 10 mm from center of lower mount bushing.
• Install tie strap over lower end of bellows, tighten, and cut off loose end of tie strap
5. Install new washer supplied in kit above the bellows boot assembly as shown.
6. Reinstall coil spring, all original upper mount parts and upper spring seat in their original positions.
7. Install new lock nut and tighten to 45 Nm (34 lb/ft). Do not re-use original lock nut.
8. Check and adjust vehicle front-end alignment after installation.