Owners manual

E4-WM5-Y339A00
MOUNTING INSTRUCTION
created: 06.12.07 E4-WM5-Y339A00_0 Page 3 of 3 latest revision: 4.30.09
3. Install the spring seat adapter (supplied) such that the groove inside the spring seat adapter fits
over the circlip on the shock body. See Figure 2. Install the spring seat adapter in the direction
shown only. The circlip must fit completely in the groove inside spring seat adapter. Improper
installation will cause permanent damage to the shock!
4. Reinstall OEM spring seat and OEM bumpstop in the direction shown only.
5. Install new washer (supplied) on piston rod as shown.
6. Reinstall the coil spring, all original upper mount parts and upper spring hat in their original
locations (reverse order of disassembly). Install new lock nut (supplied) and tighten to 45 N•m
(34 lb•ft). Do not re-use original lock nut.
7. Check and adjust vehicle front-end alignment after installation.
lock nut (supplied)
circlip (supplied)
washer (supplied)
OEM bump stop
OEM spring seat
spring seat adapter
(supplied)
Figure 2