Owners manual

E4-WM5-Y294A00 MOUNTING INSTRUCTION erstellt am: 18.08.2004 E4-WM5-Y294A00_0 Page 4 of 4 zuletzt geändert am:
refer to Figure 4):
K. Fit bumpstop (7) over rubber sleeve (3) as shown (see detail). L. Using appropriate spring compressor, compress coil spring (8) and
install to shock absorber, aligning lower coil end with end of ramp in spring seat.
M. Install upper mount (6) over piston rod end and onto top of coil
spring. Rotate upper mount (6) so that studs are in original position relative to lower mount bearing (see step B). Align end of coil spring with the rubber isolator in the upper mount.
N. Install M10 hex nut (1) and tighten to 25 Nm (19 lb/ft). O. Release spring compressor, ensuring that the ends of the coil spring
remain aligned with the spring seat (lower) and isolator (upper).
P. Install completed assembly onto vehicle and tighten all fasteners to
vehicle manufacturer’s specifications.
Q. Check wheel alignment and if necessary adjust to vehicle
manufacturer’s specifications.
Figure 4
1
6
8
2 3
7
detail