Owners manual

E4-WM5-Y294A00

MOUNTING INSTRUCTION

erstellt am: 18.08.2004 E4-WM5-Y294A00_0 Page 3 of 4 zuletzt geändert am:

A. Read all instructions on page 1.

B. Remove shock and spring unit from vehicle, following all procedures in the

vehicle manufacturer’s service manual. Note position of studs in upper

mount (6) relative to lower mount bearing (for re-assembly).

C. Using an appropriate spring compressor, compress the coil spring until

the spring can be rotated freely by hand. Then disassemble the shock

and spring unit.

D. Refer to Figure 1 to identify which original parts must be re-used.

(Refer to Figure 2):

E. Install spring seat holder (5) onto shock body (tapered side towards top.

Make sure the spring seat holder fits squarely over the circlip on the shock

body.

F. Install original spring seat (9) onto shock, over spring seat holder (5)

G. Tap or press cap (4) onto top of shock body

(refer to figure 3):

H. Install bump stop (7) over piston rod.

I. Install rubber sleeve (3) over piston rod. Push rubber sleeve onto

chromed part of piston rod (see detail).

J. Install steel spacer over piston rod, above rubber sleeve.

Figure 2

Figure 3