Owners manual

E4-WM5-Y294A01
MOUNTING INSTRUCTION
created: 09.05.09 E4-WM5-Y294A01 Page 5 of 5 latest revision:
Refer to Figure 4 for steps J through N.
J. Fit the bump stop (6) over the rubber sleeve (3) as shown (see detail).
K. Using an appropriate spring compressor, compress the coil spring (7) and install it on the
shock absorber. Align the lower coil end with end of the ramp on the spring seat (8).
L. Install the upper mount (5) over the piston rod end and on to the top of the coil spring.
Rotate upper mount so that its studs are in their original position relative to the lower
mount bearing (as noted in step A). Align the upper coil end of the coil spring with the
rubber isolator in the upper mount.
M. Install the M10 locknut (1) and tighten to 25 N·m (19 lb·ft).
N. Release the spring compressor while ensuring that the ends of the coil spring remain
aligned with the spring seat (8) and upper mount (5).
detail
6
3
1
7
5
8
Figure 4
O.
Install assembly on to the vehicle and tighten all fasteners to vehicle manufacturer’s
specifications. This completes the installation.
P. Check wheel alignment. If necessary, adjust to the vehicle manufacturer’s specifications.