Owners manual

E4-WM5-Y294A01
MOUNTI
created: 09.05.09 E4-WM5-Y294A01 Page 4 of 5 latest revision:
NG INSTRUCTION
Refer to Figure 3 for steps E through I.
E. Install the spring seat support (4) on to the shock body (with the tapered end up) such that
the groove inside the spring seat support fits over the circlip on the shock body. Install the
spring seat support in the direction shown only. The circlip must fit completely in the groove
inside spring seat support (see detail). Improper installation will cause permanent damage to
the shock!
F. Install the original spring seat (8) on to the shock and over the spring seat support (4) in the
direction shown only.
G. Install the rubber sleeve (3) over the piston rod. Push it on to the chromed part of piston rod
(see detail).
H. Install the bump stop (6) over the piston rod.
I. Install the steel spacer (2) over the piston rod, above the rubber sleeve. sleeve.
3
2
6
8
4
detail
detail
Figure 3