Owners manual

E4-WM5-Y315A01

MOUNTING INSTRUCTION

created: 07.07.09 E4-WM5-Y315A01 Page 4 of 5 latest revision:

Refer to Figure 3 for steps D through H.

Install the spring seat support (4) on to the shock body (with the tapered end up) such that

the groove inside the spring seat support fits over the circlip on the shock body. Install the

spring seat support in the direction shown only. The circlip must fit completely in the groove

inside spring seat support (see detail). Improper installation will cause permanent damage to

the shock!

Install the original spring seat (8) on to the shock and over the spring seat support (4) in the

direction shown only.

Install the rubber sleeve (3) over the piston rod. Push it on to the chromed part of piston rod

(see detail).

Install the bump stop (6) over the piston rod.

Install the steel spacer (2) over the piston rod, above the rubber sleeve.

Figure 3

detail