User's Manual

ManualsBrandsBillionton Systems ManualsElectronicsBlueEar

Bluetooth Headset

Quick Start Guide

Product Parts

1. Power/Talk/Pairing button

2. “Volume up” button

3. “Volume down” button

4. Power LED indicator: Illuminates when the Bluetooth Headset is powered on.

5. Charging/Low battery LED indicator: Illuminates when Bluetooth Headset is

charging or has a low battery.

6. Ear hook

7. Speaker

8. Microphone

9. Mini USB port: Plug in the provided USB cable to charge the battery.

10. Mono differential headphone connector (4 ports).

The Bluetooth headset can be worn on either ear. Just remove the ear hook carefully

and attach it to the other side.

Summary of content (4 pages)

PAGE 1
Bluetooth Headset Quick Start Guide Product Parts 1. 2. 3. 4. 5. Power/Talk/Pairing button “Volume up” button “Volume down” button Power LED indicator: Illuminates when the Bluetooth Headset is powered on. Charging/Low battery LED indicator: Illuminates when Bluetooth Headset is charging or has a low battery. 6. Ear hook 7. Speaker 8. Microphone 9. Mini USB port: Plug in the provided USB cable to charge the battery. 10. Mono differential headphone connector (4 ports).
PAGE 2
Charging the battery Before using the Bluetooth headset you will have to charge the battery. 1. Plug the USB cable into the mini USB port situated at the back of the headset and plug the other end into your computer’s USB port. 2. 3. 4. 5. When charging, the red LED will remain lit. The LED will turn off after the battery is fully charged. Remove the USB cable from the headset’s mini USB port. After the battery is fully charged, it will perform best. Notice: I.
PAGE 3
phone: 1. Follow the operating instructions that came with your Bluetooth phone to start the pairing process. 2. Ensure the Bluetooth headset is powered OFF. 3. Press and hold the “Power” button for approximately 8 seconds until the Power LED (4) and the Charging LED (5) start to flash alternately. 4. Release the “Power” button when the LED’s start to flash alternately. This indicates that the headset is in pairing mode and waiting to be paired with another Bluetooth device. 5.
PAGE 4
FEDERAL COMMUNICATIONS COMMISSION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.