BiPAC 9800(N) (802.
Quick Start Guide 85
Billion BiPAC 9800(N) (802.11n) Fiber Optical Router PLEASE READ THE QUICK START GUIDE AND FOLLOW THE STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON CD-ROM. Package Contents BiPAC 9800(N) (802.
Quick Start Guide Hardware Overview The Front LEDs When the power is on it will be lit green. When the system is booting it will blink orange. When the system is ready it will be lit green. When system boot fails or if in emergency mode, it will be lit orange. Lit orange when one of LAN ports is connected to an Ethernet device. Lit green when the speed of transmission hits 1000Mbps; Lit orange when the speed of transmission hits 10/100Mbps. Blinking when data is transmitted/ received.
Billion BiPAC 9800(N) (802.11n) Fiber Optical Router • 100BASE-BX: A single strand of optical fiber. Single-mode fiber is used. It supports SC connector. • 1000BASE-BX: A single strand of optical fiber. Single-mode fiber is used. It supports SC connector. Dual SC Ports Dual fiber WAN interface is separated into single-mode and multi-mode. Connect the fiber cable to the WAN port. There are 3 options for dual SC interface: 100Base-LX/ SMF, 1000Base-LX/SMF and 100Base-FX/MMF, and they do not coexist.
Quick Start Guide SFP Port Install the Mini-GBIC module into the SFP cage. Connect the fiber cable to the fiber port of Mini-GBIC module. We offer 2 types of SFP interfaces: 100Base-SFP and 1000Base-SFP, and *2 they do not coexist. Please refer to the figure shown below. A cage for SFP (Small Form-Factor Pluggable) transceiver- 100BASE or 1000BASE optical convector. Attention Note that apply 100Base SFP module into the device with 100Base-SFP WAN interface.
Billion BiPAC 9800(N) (802.11n) Fiber Optical Router Hardware Connection Hardware Installation 1. Power Connection Plug the supplied power adapter into the wall jack and the other side to the router. Please note that the plug type may differ according to country.
Quick Start Guide 2. LAN Connection Connect the supplied RJ-45 Ethernet cable to one of the Giga Ethernet ports, and the other side to the PC’s Ethernet interface. 3. Fiber Connection Please follow the illustrations below to connect the fiber cable or module and the router. Attention Warning The type of fiber interface varies from device models provided by your ISP. Please find the exact WAN interface on the label of outer box, or label of the bottom of device for the specification of your device.
Billion BiPAC 9800(N) (802.11n) Fiber Optical Router b) LX/ FX Insert the dual fiber cable into the TX and RX jacks separately of the router. c) SFP Set the Mini-GBIC module in the SFP port of your device, and then connect the fiber cable to the module. Connecting to the Router 1. Open the web browser and type http://192.168.1.254 in the browser's address box. This number is the default IP address for this router. Press Enter. 2. A username and password window will appear.
Quick Start Guide Troubleshooting 1. None of the LEDs lit when the router is turned on. Examine the connection between the router and the adapter. If the problem persists, most likely it is due to the malfunction of your hardware. Please contact your service provider or Billion for technical support. 2. You have forgotten your login username and/or password. Try the default username & password (please refer to User Manual).
