User`s manual

VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
Chapter 4: Configuration
33
The Active PC in LAN screen displays a list of individual Ethernet device IP Address & MAC Address that
are currently connected to the router.
Select individual devices to be blocked or allowed, by checking the box next to the IP address. Then, Add
to insert to the Ethernet Client Filter table. The maximum number of Ethernet clients is 16.
Wireless
(Wireless Router only)
Parameters
WLAN Service: Default setting is set to Enable. If you do not have any wireless, both 802.11g and
802.11b, device in your network, select Disable.
Mode: The default setting is 802.11b+g (Mixed mode). If you do not know or have both 11g and 11b
devices in your network, then keep the default in
mixed mode
. From the drop-down manual, you can
select 802.11g if you have only 11g card. If you have only 11b card, then select 802.11b.
ESSID: The ESSID is the unique name of a wireless access point (AP) to be distinguished from another.
For security propose, change the default wlan-ap to a unique ID name to the AP which is already built-in to
the router’s wireless interface. It is case sensitive and must not excess 32 characters. Make sure your
wireless clients have exactly the ESSID as the device, in order to get connected to your network.
Note:
It is case sensitive and must not excess 32 characters.
ESSID Broadcast: It is function in which transmits its ESSID to the air so that when wireless client
searches for a network, router can then be discovered and recognized. Default setting is Enabled.


 Disable: If you do not want broadcast your ESSID. Any client using the “Any” wireless setting
cannot discover the Access Point (AP) of your router.


 Enable: Any client using the “Any” setting can discover the Access Point (AP) in this mode.
Regulation Domain: There are seven Regulation Domains for you to choose from, including North