User`s manual

VoIP/(802.11g) ADSL2+ (VPN) Firewall Router
Chapter 4: Configuration
148
Ethernet: P1 (Port 1)
Ethernet1: P2, P3 and P4 (Port 2, 3, 4) Please uncheck P2, P3, P4 from Ethernet VLAN Port first.
Note: You should setup each VLAN group with caution. Each Bridge Interface is arranged in this order.
Bridge Interface VLAN Port (Always starts with)
ethernet P1 / P2 / P3 / P4
ethernet1 P2 / P3 / P4
ethernet2 P3 / P4
ethernet3 P4
Step 2: Create WAN Interface
Go to Configuration 

 WAN

 ISP
wanlink is the factory default WAN interface used for data/internet access. If your ISP uses this access
protocol, click Edit to input other parameters if needed. If your ISP does not use PPPoE, you can change
the default WAN connection entry by clicking Change.
From the example, 0/40 is used for data/internet and assumes PPPoE is used; click Edit to change the
VPI/VCI to 0/40.
Click
Create
to setup up an additional WAN interface for video applications. A total of eight VLANs are
supported ie only eight WAN interfaces can be created in the table.
From the example, PVC 0/33 to 0/39 is assigned for video using 1483 Bridged mode. Check RFC 1483
Bridged and click Next to continue the setup.