User manual

2.4 The Rear Ports

BiPAC 7300N RE

Port Description

1 Antenna

Connect the antenna to this port.

2 ON/OFF

Power ON/OFF switch.

3 Power

Connect the supplied power adapter to this jack.

4 Reset

After the router is powered on, press this reset button using the

end of paper clip or other small pointed object for 6 seconds and

above to restore it to factory default settings.

1. Recovery procedures for non-working routers (e.g. after a

failed firmware upgrade flash).

2. Recovery procedures for a lost web interface password.

5 WPS

Press the WPS button acoording to the following two to achieve

different functions.

(1)WPS: Press 2-6 seconds until WPS LED flashes green to

trigger WPS function.

(2) Wireless ON/OFF Switch: Press over 6 seconds after WPS

LED is off to switch on wireless function. Press over 6 seconds

again for disable wireless function.

6 Ethernet

Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to one of the

four LAN ports when connecting to a PC or an office/home

network of 10Mbps or 100Mbps.

Note: Only Ethernet port 1 can be used for EWAN.

7 DSL

Connect the supplied RJ-11 (“telephone”) cable to this port when

connecting to the ADSL/telephone network.