BIPAC 6600 Broadband Firewall Router Quick Start Guide
Billion BIPAC 6600 Broadband Firewall Router For more detailed instructions on configuring and using the Broadband Firewall Router, please refer to the on-line manual. Package Contents BIPAC 6600 Broadband Firewall Router CD-ROM containing the online manual Ethernet (CAT-5 LAN) Cable AC-AC power adapter (9V AC, 1A) This Quick Start Guide Do not use the BIPAC 6600 in high humidity or high temperatures. Do not use the same power source for the BIPAC 6600 as other equipment.
Quick Start Guide The Front LEDs 1 5 3 2 4 LED 2 Meaning 1 PWR Lit green when power adapter is connected. 2 SYS Lit when the system is ready 3 WAN Lit green when connected at 100 Mbps. Lit orange when connected at 10 Mbps. Flashes when sending/receiving data. 4 PPP Lit green when PPPoE connection is established. 5 LAN Lit green when the relevant LAN link is connected.
Billion BIPAC 6600 Broadband Firewall Router The Rear Ports 3 1 2 4 Port Meaning 1 PWR Connect the supplied power adapter to this jack. 2 RESET Press it to restore the factory default setting back. WAN Connect an UTP Ethernet cable to this port when connecting to a hub. 3 (RJ-45 connector) LAN 4 (RJ-45 connector) Connect a crossover cable to this port when connecting to a DSL/Cable bridge or modem for establishing WAN connections.
Quick Start Guide Configuring PC in Windows XP 1. Go to Start / Control Panel (in Classic View). In the Control Panel, double-click on Network Connections 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window, click Properties. 4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration.
Billion BIPAC 6600 Broadband Firewall Router Configuring PC in Windows 2000 1. Go to Start / Settings / Control Panel. In the Control Panel, double-click on Network and Dial-up Connections. 2. Double-click Local Area Connection. 3. In the Local Area Connection Status window click Properties. 4. Select Internet Protocol (TCP/IP) and click Properties. 5. Select the Obtain an IP address automatically and the Obtain DNS server address automatically radio buttons. 6. Click OK to finish the configuration.
Quick Start Guide Configuring Your Broadband Firewall Router To configure this device, you must have IE 5.0 / Netscape 4.5 or above installed Verifying Your Local Network Connection with the Device To see if this Router is visible on the local network, go to Start / Run. In the Run dialog box, type “ping 192.168.1.254” then press OK. A command prompt window will pop out.
Billion BIPAC 6600 Broadband Firewall Router Connecting to the Router 1. Open the web browser and type http://192.168.1.254 in the browser’s address box. This number is the default IP address for this router. Press Enter. 2. A username and password window will appear. Press OK to proceed if you do not set any user name and password. Product Support and Contact Information Most problems can be solved by referring to the Troubleshooting section in the User Manual.
