User manual

Get IP Address: Choose Static or Dynamic for the type of IP address you want to get.

Static IP Address: Enter the IP address of ADSL Router in dotted decimal notation, for

example, xx.xx.xx.xx.

IP Subnet Mask: The default is 0.0.0.0. User can change it to other such as

255.255.255.0.Type the subnet mask assigned to you by your ISP (if given).

Gateway: You must specify a gateway IP address (supplied by your ISP) when you use

1483 Bridged IP in the Encapsulation field in the previous screen.

NAT: Select this option to Activate/Deactivated the NAT (Network Address Translation)

function for this VC. The NAT function can be activated or deactivated per PVC basis

Default Route: if this function is enabled, the current PVC will be the default gateway to

access Internet from this device

TCP MTU Option: Enter the TCP maximum transmission unit (MTU)

Dynamic Route:

RIP Version: (Routing Information protocol) Select this option to specify the RIP version,

including RIP-1, RIP-2M and RIP-2B. RIP-2M and RIP-2B are both sent in RIP-2 format; the

difference is that RIP-2M uses Multicast and RIP-2B uses Broadcast format

RIP Direction: Select this option to specify the RIP direction. Select None to disable the RIP

function. Select Both will activate the ADSL Router to periodically send routing information

and accept routing information for incorporation into the routing table. Select IN will

configure ADSL router to only accept RIP packet but not to send RIP packet. Select OUT will

configure ADSL router to only send RIP packet but not to accept RIP packet.

Multicast: IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to

establish membership in a Multicast group - it is not used to carry user data. Select None to

disable this function.

MAC Spoofing: Select Enable and enter a MAC address that will temporarily change

your router’s MAC address to the one you have specified in this field. Leave it as Disabled if

you do not wish to change the MAC address of your router.

Press SAVE to confirm your configuration.