User`s manual

13
2.4 Configuring Password
It is highly recommended that you change the password for accessing the
BIPAC-5100/5100W.
To change the BIPAC-5100/5100W’s password, click Advanced Setup and then Password.
The screen appears as shown.
The following table describes the labels in this screen.
LABEL DESCRIPTION
Old Password Type the default password or the existing password you use to access the
system in this field.
New Password Type the new password in this field.
Retype to Confirm Type the new password again in this field.
Apply
Click Apply to save your changes back to the BIPAC-5100/5100W.
Cancel
Click Cancel to begin configuring this screen afresh.
2.5 Resetting the BIPAC-5100/5100W
If you forget your password or cannot access the BIPAC-5100/5100W, you will need to reload
the factory-default configuration file or use the RESET button the back of the
BIPAC-5100/5100W. Uploading this configuration file replaces the current configuration file
with the factory-default configuration file. This means that you will lose all configurations that
you had previously and the speed of the console port will be reset to the default of 9600bps
with 8 data bit, no parity, one stop bit and flow control set to none. The password will be reset
to “admin”, also.