User manual

TELKOM VPN-Lite 2.3 ver.080311 Page 6
Internet Service Provider Account Setup
Select “Activate Internet Account configuration” tick box to set your Internet username and password.
You can now enter your ISP username and password to connect to the internet. Your service provider
will provide you with this information.
VPN Lite – Local Site Configuration
Before you start with this section, please make sure you have registered on the VPN-Lite service
website and that you have received your VPN-Lite account and IP information for the local site (this
will be one of your branches or offices where you will install the VPN-Lite service). Please refer to the
Before you start section in this document on page 4 for additional information.
To change these settings select “Activate VPN Lite configuration”.
By using the information retrieved from the Telkom VPN-Lite setup website (see page 4) enter your
site username, site password and site LAN IP range using the IP slash notation as it appears on the
Telkom VPN-Lite website.
Advance Settings
In the advance settings you can enable or disable the router’s DHCP settings. Please remember that
if you disable the DHCP settings you will loose connection to your router after the settings have been
updated, as the static IP address would have been changed to another IP range. You can also set
your DHCP start and end range.
To save the settings press Save Settings and wait for the application to complete the setup process.