User manual

TELKOM VPN-Lite 2.3 ver.080311 Page 11
c. Set your router’s LAN IP address: Please run the following command to set your router’s LAN
IP address to within the correct target IP range. (Note that if using DHCP server, this LAN IP
must be in that same IP range).
Note that your telnet session will become unresponsive after you execute the command and will
eventually terminate. This is due to the router’s altered LAN IP that was originally used to setup the
Telnet connection, but has now been changed.
Syntax: ip set interface iplan ipaddress <LAN IP> <Subnet>
Example: ip set interface iplan ipaddress 10.0.17.2 255.255.255.0
Please see the correct LAN IP target range for your local site indicated on the VPN-Lite web
page screen shot below.
Note that the router uses the subnet syntax instead of the slash notation (/24) used to display
the LAN IP range on the website. Use the table below to translate the slash notation to the
subnet mask syntax.