B–4000 Instant Boiling and Ambient Filtered Water System User guide
User guide B–4000. Thank you for choosing to install a Billi B–4000 Instant Boiling and Ambient Filtered Water System. Your B–4000 is manufactured to exacting standards using high quality materials and with proper maintenance and care, should function for many years. The Billi service representative to contact for any service requirements or to supply replacement filter cartridges is: Insert agent details Filter cartridges are also available online at www.billihome.com.
User guide B–4000.
User guide B–4000. —Limitation of liability 3.
User guide B–4000. – WARNING: Do not connect any restrictor or pressure relief device to the vent pipe of this water heater if installed. – If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid creation of a hazard. – New hose sets supplied with the appliance are to be used. Old hose sets should not be re-used.
User guide B–4000. Normal operation —Dual action levers To dispense drinking water from your Billi B–4000, the hot or ambient levers may be depressed or lifted. When lifted, the levers will latch for continuous delivery until released with a light press. The B–4000 will not dispense hot and ambient water simultaneously. Water will not flow if both levers are pressed together.
User guide B–4000. for a period of up to 10 seconds from the last dispense. During this mode, the red hot cup icon is on, and then gives 2 rapid flashes every 2 seconds. To activate, refer to Options, page 8. —Holiday mode Holiday Mode is provided to save energy when the unit will not be used for long periods. In this mode the water heater is disabled and the unit will use very little power. Pressing the Pressure Relief button places the unit in Holiday Mode.
User guide B–4000. Options Operating modes can be selected by the user by entering Options Mode. Within the Options Mode, you can set the safety switch through the hot water lever and power save mode through the ambient water lever. –To enter Options Mode 1. Turn on the unit and wait for normal operation (icons are both illuminated constantly). 2. Push both the Hot and Ambient levers down and while holding the two levers down press the safety switch (located at the back of the tap).
User guide B–4000.
User guide B–4000. Billi Filter Cartridges The Bill B–4000 is fitted with single dual action filter incorporating sediment and chemical removal elements. All Billi B–4000 filters are manufactured using bacteria and biofilm resistant materials for improved water quality. Premium filters provide a better tasting water due to the high quality, carbon chemical removal filter.
User guide B–4000. Filter removal and replacement instructions 1. Remove the front panel, see Diagram 1. 2. Place the unit in Holiday Mode by pressing the Pressure Relief button once. The lights on the dispenser will alternate and then go off, see Diagram 2. 3. Hold filter and swing towards you slowly. The top of the filter is in a hinged cradle assembly. It should stop after approximately 30 degrees of travel, see Diagram 3. 1. 4.
Billi Pty Ltd 42 Lucknow Crescent, Thomastown Victoria 3074 Australia Telephone +61 3 9469 0400 Facsimile +61 3 9469 0499 www.billihome.com.au Designed and manufactured in Australia. As Billi Pty Ltd has a policy of continual improvement, all details are subject to change without notice. All goods are sold subject to our published terms and conditions. Billi is a registered trademark.
