User guide

www.billetspecialties.com • Tech Line 708.588.0505

LSx Top Mount Tru Trac - 13450 / 13470

Figure 4: Install Tensioner & Bracket

Apply anti seize to the threads of the following:

(1) 8mm-1.25 x 25mm ARP 12pt. cap screw

(2) 8mm-1.25 x 25mm flat head cap screws

(1) 5/16-18 x 1” hex head bolt

[A] Thread the 5/16” hex head bolt and 5/16” flat washer through the back of the tensioner

bracket. Place the bracket with the bolt and washer hanging through it on the passenger

side of the water pump.

[B] Thread the two 8mm flat head cap screws through the bracket and into the bottom

standoffs.

[C] Finish by threading the 8mm ARP 12pt. cap screw through the top hole in the bracket

and into the top standoff. Tighten the three fasteners firmly.

[D] Align threaded hole in the back of the tensioner with the threads of the 5/16” hex head

bolt and washer sticking through bracket, finger tighten tensioner to bracket while aligning

the top tensioner holes with the bracket.

Figure 3: Install Compressor Bracket

Apply anti seize to the threads of the three 10mm-1.5 x 20mm socket head cap screws.

[A] Place compressor bracket onto water pump bosses as shown and attach with two of the

10mm-1.5 x 20mm socket head cap screws. Tighten firmly.

Note: If bracket interferes with water pump it is upside-down.

[B] Follow by aligning recess in rear compressor bracket with keyway in installed bracket.

Thread the final 10mm-1.5 x 20mm socket head cap screw through installed bracket and into

rear compressor bracket. Tighten firmly.

Note Hole Position On BracketA A

D D