User guide

www.billetspecialties.com • Tech Line 708.588.0505
18
LSx Top Mount Tru Trac - 13450 / 13470
19
Figure 13: Install Belt & Tensioner Pulley
Route belt as shown below minus tensioner pulley.
[A] Place a 5/8” socket attached to a breaker bar on tensioner nut at approximately the
12 o’clock position, align belt onto grove of tensioner pulley.
[B] Pull breaker bar clockwise until tensioner boss lines up with hole in tensioner pulley, slide
pulley onto boss and slowly return wrench to starting position, applying tension to the belt.
Apply anti-seize to the threads of the 3/8-16 x 3/4” ARP 12pt. cap screw.
[C] Thread ARP 12pt. cap screw with aluminum washer onto tensioner boss and tighten firmly
(46 ft/lbs.).
Figure 14: Install Compressor Manifold
Continue with this step ONLY if you are going to be installing your air conditioning hoses and
charging your system at this time.
Remove the plate on top of the compressor body.
Apply anti-seize to the following:
(2) 8mm-1.25 x 25mm socket head cap screws
[A] Install compressor manifold onto compressor with the two 8mm-1.25 x 25mm socket head
cap screws and tighten firmly (13 ft/lbs).
Install hoses, connect clutch wire and charge system.
IMPORTANT
If you are NOT installing hoses and charging system at this time, place compressor manifold
and hardware in a safe place and leave cover plate on compressor at this time.
Do not connect clutch wire or apply power to clutch wire without the hoses connected and
system charged – serious damage will occur to compressor.
Compressor Oil
Although the compressor is supplied with oil, the level may not be correct for the entire
system. Consult the instruction manual of the air conditioning unit for proper levels and
system charging procedures.
This compressor is designed for use with Air Conditioning units only. Serious damage will
occur to AC compressor if used for anything other than its intended purpose.
Warranty is Void if used for any non-AC application.
WITH POWER STEERING WITHOUT POWER STEERING
A AB
C