Owner's manual

www.billetspecialties.com
Figure 11: Attaching Alternator
To install the alternator insert the alternator behind the bridge
bracket and install the 10mm-1.5 x 80mm 12 pt. cap screw in
the lower alternator mounting hole. The alternator mounting
boss may vary in width in the polishing process. 10mm shim
washers are provided to shim alternator to bridge bracket
(washers may not be needed). Complete alternator installa-
tion using one 8mm-1.25 x 25mm 12 pt.
cap screw to attach the top ear of the alternator to the
bridge bracket.
Figure 12: Finish Bridge Bracket Installation
At this point we are ready to tighten the long spacer nuts
and hex flange bolt on tensioner bracket. Once these are
tightened you may then tighten all bolts on the bridge
bracket assembly.