Owner's manual

www.billetspecialties.com
Figure 7: Install the Tensioner
Thread 8mm-1.25x25mm socket set stud into the tensioner
spacer nut with boss, tighten with 4mm allen key (stud installs
in spacer nut opposite of boss). Attach the tensioner spacer
nut with boss to the backside of tensioner. Attach assembly
to lower water pump spacer bracket ear with 3/8-16x1” Hex
Flange Bolt. Do not completely tighten at this time.
Figure 8: Install Power Steering Bracket, Pump & Pulley
Install the power steering bracket using two 7/16-14x2-1/4”
socket head cap screws on the lower end of the alternator
bracket and tighten. Attach the power steering pump and
pulley assembly to the power steering bracket using two
5/16-24 x 3” socket head cap screws & two 5/16” lock
washers. If your kit does not use power steering proceed
to Figure 9.
Tensioner Spacer Nut x1
8mm-1.25x25mm
Socket Set Cup Point