Owner's manual

www.billetspecialties.com
Figure 2: Install Mounting Studs
Install the four 3/8-16x3” block mounting studs until the
threads are completely screwed into the block. Two 3/8-16
nuts can be tightened against each other to act as a drive
nut to ease installation (see illustration below*). Use an RTV
silicone sealant on the threads and seat them firmly into
the block.
Figure 1: Prepping The Block
Start by removing any accessories that may be on the motor.
To ease in the installation of the studs and fasteners, chase
the water pump mounting threads with a 3/8-16 tap and the
threads on the two lower bosses on either side of the balanc-
er with a 7/16-14 tap. Make sure block face is clean and free
of gasket material.
*Example