Manual

www.billetspecialties.com

Figure 9: Attaching Bridge Bracket

A] Install the bridge bracket to the three water pump spacer nuts, the top

front, and bottom front compressor ear by applying anti-seize to and using

ve 8mm-1.25 x 25mm 12 pt. cap screws.

B] The bridge bracket also attaches to the tensioner using a

8mm-1.25 x 40mm at socket cap screw (installs in lower boss through

bracket and tensioner into spacer nut), and a 8mm-1.25 x 25mm at

socket cap screw (installs through bracket into tensioner).

NOTE: Apply anti-seize to threads before installing. The compressor

shoulder bolt on the lower rear ear and/or water pump spacer nuts may

need to be loosened to help align the bridge bracket with screw holes.

Figure 10: Attaching Alternator

A] Place the alternator behind the bridge bracket apply anti-seize to

threads and install the 10mm-1.5 x 80mm 12 pt. cap screw in the lower

alternator mounting hole.

Note: The alternator mounting boss may vary in width due to the

polishing process. 10mm shim washers are provided to shim alternator to

bridge bracket (washers may not be needed).

B] Complete alternator installation using one 8mm-1.25 x 25mm 12 pt.

cap screw by applying anti-seize to threads and threading through the

bridge bracket into the top ear of the alternator.

At this point we are ready to tighten the hex ange bolt on tensioner

bracket and compressor shoulder bolt. Once these are tightened you

may then tighten all bolts on the bridge bracket assembly.