User manual

Fixed Wireless/Wired IP Camera

2. Hardware description and quick installation/usage

The IP CAM is designed to be very easy to install and use. First, let’s see the major

components of the IP CAM products.

2.1. Major hardware components.

The major components on the

front panel

of the IP CAM products are the built-in

microphone, lens and LEDs :

1. Microphone - for receiving the audio/voice. Effective distance is about 5 meters.

2. Lens - the focus of the lens is fixed, you do not need to spend time to adjust the

focus, the effective focus range is from 40cm to infinity.

3. Status indication LED (red) - this LED is to indicate the Internet connection status.

When the Internet connection is connected, the LED will be constant red light. If

there is any Internet connection problem, the LED will be blinking red light.

4. Ethernet indication LED (blue) - this LED is to indicate if the Ethernet link is ok

and packet traffic is sending/receiving. When the Ethernet cable is connected, the

LED is constant blue light. When there is packet sending/receiving, the LED is

blinking blue light.

Figure 2-1: Major components in the front panel

The major components on the

back panel

of the IP CAM products are the bracket

screw jack, power jack, Ethernet jack and reset button:

1. Bracket screw jack - this is the position to screw in the bracket of the IP CAM.

With the bracket, you can put the IP CAM on the desk, on the wall or on the

ceiling.

2. Power jack - this is the place to plug in the power adaptor. The power needed for

this IP CAM is 5V/1.0A, please make sure you are using the correct power

adaptor.