User manual

Fixed Wireless/Wired IP Camera

3.6. Video Settings

The IP CAM is designed to provide high quality video for viewing from CamView

software. In this page, you cam modify some settings related to the video viewing: 1.

Password(play video) - this is the password needed for viewing the video from the

CamView software. Together with the IP CAM ID, you can view the video of this IP

CAM anywhere in the world through the Internet.

2. Internet speed - this is the Internet bandwidth of your network environment.

Higher value will generate higher video quality. But if your internet connection can

not provide more bandwidth than the specified value, the video quality could

degrade. So, please key in a value that is lower than your internet bandwidth.

3. Select resolution & frame rate automatically - you can let the system select the

suitable video resolution and frame rate automatically for you. The selection is

based on the “Internet speed” value. This is the recommended default setting.

4. Resolution - there are three choices : 160x120, 320x240 and 640x480. If you

decide to choose the value manually, you can choose one of the three values. But,

please be noticed that if the Internet speed is slow(low value), high

resolution(640x480) or frame rate could cause very bad video quality.

5. Frame rate - the video frame display rate. Higher value means faster movement

and continuity in the video display.

6. Brightness - the brightness of the video, lower value means darker display.

7. Outdoor/Indoor video - for better video display quality, modify this setting when

taking indoor or outdoor video. The default setting is “Outdoor video”, in most

cases, this is also ok for indoor usage. Under some special cases, there could be

some strip lines on the video display when the IP camera is taking indoor video. In

this situation, change the setting to “Indoor video” will solve the problem. Please

also be noticed that in “Indoor video” setting, the video display of outdoor view is

very vague.

8. Enable/disable audio microphone - you can enable or disable the audio

microphone on the IP CAM. If disable, there will be no voice on the CamView

video viewing.

When this modification is “Save&Apply”ed, it works immediately, but all the

connected video viewing users will be disconnected.