User manual

FOLDING BIKE
24
HandleBar
HEIGHT
The handlebars position is fixed to the
optimal position for the most people. It is
not adjustable.
ANGLE
Due to the specifics of the folding
handlebars, changing and adjusting the
angle of the handlebars is not possible.
Never ride the Bigfish folding bike if the stem
has been raised so that the minimum insertion
mark can be seen.
STEERING
Ensure handlebar and stem are correctly
adjusted and tightened, and allow proper
steering. Ensure that the handlebars are
set correctly in relation to the forks and
the direction of travel. Check that the
headset locking mechanism is properly
adjusted and tightened.
ImPOrTanT nOTes
rePlaCemenT ParTs
Many parts of your Bigfish folding bike
are safety critical ones, such as the
frame, forks, handlebar, handlebar stem,
seat post, cranks, pedals, wheel rims,
chain, brake levers, brake cables, etc.
For these components we recommend
only genuine replacement parts are used
as only these can guarantee optimum
function and safety while riding. If you are
not confident about what size or type of
component you require as a replacement,
seek advice from your dealer or contact
us at info@bigfishbike.com.
Battery does not contain serviceable
parts.
BaTTerY
CHARGING THE BATTERY
The battery can be charged mounted or
unmounted.
1 - Turn the system off.
2 - Connect the battery to the charger;
ensure the output terminal of the charger
and the input terminal of the battery are
firmly connected.
3 - Connect the connector of the power
supply to the charging port of the battery
and connect the power supply to the
power outlet.
Fully charging will typically take 2 hours.
Make sure the power cord, battery cable,
and battery terminals are in good condition.
Never use damaged power cable. Replace it
immediately to prevent an electric shock.
Ensure the input voltage is between
100V~240V. Before plugging in the power
cord of the charger, make sure that the
local power supply corresponds with the
requirement of the charger. Using the
wrong voltage setting will permanently
damage the charger and/or electrical
components on the bike.