User Manual

10
TO ADD JACK OIL
TO REPLACE JACK OIL
The hydraulic cylinder assembly contains hydraulic
uid that must be kept at approximately 80% full at
all times for proper operation. To check the level and
to ll remove oil ller plug.
1. Position the jack on level ground and lower the
saddle.
2. Remove the oil plug.
3. Fill the oil case until oil level to 80% full.
4. Replace oil plug.
5. Perform the Air Purge Procedure.
1. Position the jack on level ground and lower the
saddle.
2. Open release valve by turning handle counter-
clockwise (4 full turns).
3. Remove the oil ll plug.
4. Turn the jack on its side so that old oil will drain
from the oil ll hole.
5. Position the jack on level ground and lower the
saddle.
6. Fill the oil case until oil level to 80% full.
KEEP DIRT AND OTHER MATERIALS CLEAR
WHEN POURING.
7. Replace oil plug.
8. Perform the Air Purge Procedure.
on level ground and lower the saddle
7