Instruction manual

CR3805-S THE STEALTH
™
WARNING! Read all assembly, field assembly and safety instructions prior
to using this product! Failure to follow the instructions on this page and pages
64-67 may result in serious injury or death!
NOTE: Steps 1-4 require you to temporarily finger tighten nuts to insure proper
alignment. All bolts should be installed from the inside with nylock nuts on the outside.
STEP 1: Attach the top ladder extensions to the top ladder section using (2) snap pins.
Note: When attaching top ladder extensions be sure that the bends are facing outward.
STEP 2: Next sleeve the side frames onto the top ladder extensions. Then attach
the platform supports to the inside of each side frame/top ladder extension
using (2)
1
⁄4" x 1
3
⁄4" hex bolts [C] and (2) ¼" nylock nuts to secure.
STEP 3: Attach the foot platform to the top ladder extension using (2) ¼" x 2
¼" hex bolts [D] and (2) ¼" nylock nuts to secure. Then attach the platform
supports to the foot platform using (2) ¼" x 1 ¼" hex bolts [A] and (2) ¼" nylock nuts.
STEP 4: Slide the seat cushion support and 1" nylon strap onto the side frames.
NOTE: Do not finish threading and tightening seat cushion support at this time.
Then attach the rear frame support to the side frames using (4) ¼" x 1 ½" hex bolts
[B] and (4) ¼" nylock nuts to secure.
STEP 7: SECURELY TIGHTEN EVERY NUT AND BOLT AT THIS TIME.
STEP 8: At this time the seat cushion support should be threaded and tightened.
You are now ready to install your ladderstand,
see page 66.
Parts List (CR3805-S)
Description Qty
Top Ladder Section 1
Middle Ladder Section 1
Bottom Ladder Section 1
Foot Platform 1
Rear Frame Support 1
Support Bar – Tree Piece 1
Support Bar – Ladder Piece 1
Side Frame 2
Top Ladder Extension 2
Platform Support 2
Seat Cushion Support 1
Full Body Harness 1
Ratchet Strap 1
Rope 1
Stabilizer Strap 2
Owners Manual 1
Hardware Pack
[A] 1/4" x 1 1/4" Hex Bolt 2
[B] 1/4" x 1 1/2" Hex Bolt 4
[C] 1/4" x 1 3/4" Hex Bolt 3
[D] 1/4" x 2 1/4" Hex Bolt 2
1/4" Nylock Nut 10
1/4" Wing Nut 1
Snap Pin 7
22
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.