Instruction manual

READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This instruction manual complies with the Treestand Manufacturers Association’s TMS 04 - Standard Practice for Treestand Instructions and TMS 02 - Standard Test Method for Treestand Fall Arrest Systems.
ATTENTION!! WHEN YOU SEE A “ WARNING!” BE SURE TO HEED THE MESSAGE!
THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!!

Part B
(Ladder Piece)
Top
Ladder Section
Middle
Ladder Section
Rope
Part A
(Tree Piece)
Snap Pin
Receiver
SNAP PIN ILLUSTRATION

front of tubing and secure
over end of pin.
Installed and
in the closed
position
STEP 1. Assemble adjustable support bars by sliding Part A into the Part B. NOTE: The snap pin will be used to set the desired length of the
adjustable support bars.
STEP 2. Attach support bar to ladder using remaining bolts and wing nuts. NOTE: These gures relate to Step 5 of the Installation Instructions
from page 13.
ADJUSTABLE SUPPORT BARS
FIELD INSTALLATION  LADDERSTANDS
ADJUSTABLE SUPPORT BAR ASSEMBLY