Instruction manual

20
FIELD INSTALLATION -
FIXED POSITION TREESTANDS
WARNING! Read all assembly instructions, field assembly instructions and
safety warnings prior to using this product! Failure to follow these instructions
may result in serious injury or death!
WARNING! Prior to attempting to use this or any other Big Game product(s),
you should take a moment to become familiar with its installation, set-up,
and use. We recommend that you practice installing, setting-up, and using
this product on the ground prior to attempting to use it at the desired height;
once you are comfortable at ground level you are ready to install and use the
product at your desired height!
WARNING! This treestand was designed to be used on trees with a
MINIMUM DIAMETER OF 9-INCHES. DO NOT use on trees with smaller
diameters. Failure to follow this warning may result in serious injury or death!
WARNING! Never install, set-up, or climb to your treestand with a weapon.
Use a pull up rope to carefully raise your unloaded weapon after safety harness
is secure and you are set in the stand!
STOP NOW! It will be necessary to use the climbing tree belt with your
full body harness while ascending the tree and attaching your treestand. As
you climb it will be necessary to slide the climbing tree belt up the tree. Once
you’ve reached the desired height and your treestand is properly secured to
the tree, you will need to attach the permanent tree belt and secure tether
strap as illustrated on page 9 of this manual. FAILURE TO WEAR YOUR FULL
BODY HARNESS AT ALL TIMES WHILE USING THIS PRODUCT MAY RESULT
IN SERIOUS INJURY OR DEATH!
STEP 1. Fold treestand platform to the upright position and hold to desired
mounting position against the tree. (see fig. 1)
STEP 2. Lengthen strap by pulling slide buckle. Wrap strap around tree. (see fig. 1)
STEP 3. Attach J-hook onto strap hook receiver. Pull strap tight. (The platform
must be in the upright position while doing the above steps.) (see fig. 2)
STEP 4. Lower platform to standing position; the treestand will then snug up to the tree
to prevent any shifting. Redo as necessary to accomplish a snug fit to the tree. (see fig. 3)
WARNING! Make sure that you are wearing a full body harness! Ensure
that the tree belt is tightened around the tree and the full body harness is
attached properly!
STEP 5. Before stepping onto the stand, be sure it is secured properly and is tight
against the tree with all four contact points touching the tree.
WARNING! Never step onto a treestand until all contact points are in tight
contact with the tree and your Full Body Harness is properly attached using
the tree belt & tether strap! Failure to follow these instructions may result in
serious injury or death!
STEP 6. Carefully step onto the stand to be sure you have a solid feel against the
tree. The seat folds down for sitting or up for standing. (see fig. 4)
STEP 7. Carefully pull up your unloaded weapon.
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.