Instruction manual

ATTENTION!! WHEN YOU SEE A “ WARNING!” BE SURE TO HEED THE MESSAGE!
THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!!
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This instruction manual complies with the Treestand Manufacturers Association’s TMS 04 - Standard Practice for Treestand Instructions and TMS 02 - Standard Test Method for Treestand Fall Arrest Systems.
8 8
CR3811-S The WaRRioR DX
WARNING! Read the WEIGHT RESTRICTION WARNING, USAGE
INSTRUCTIONS & WARNINGS and FULLBODY FALL ARREST
HARNESS USAGE INSTRUCTIONS & WARNINGS on pages 3-7 prior
to assembly of this product! Failure to follow the instructions on this
page and pages 3-7 may result in serious injury or death!
WARNING! DO NOT over tighten the hardware. Over tightening can
lead to structural damage and may negatively aect the performance
of your stand. Failure to follow these instructions may result in serious
injury or death!
    Field Installation-Ladderstands, for installation
instructions.
NOTE:           
proper alignment. All bolts should be installed from the inside with nylock nuts
on the outside.
STEP 1. Attach the top ladder extensions to the top ladder section using
(2) snap pins. NOTE: top ladder extensions be sure that the

STEP 2. side frames onto the top ladder extensions. Then
attach the platform supports to the inside of each side frame/top ladder
extension

STEP 3. Attach the footrest and foot platform to the top ladder sections

to secure. Then attach the platform supports to the foot platform using (2)

STEP 4. 
seat platform to the side frames (Fig. 2).
STEP 5:armrests to the side frames
NOTE:shooting
rail holes should be to the rear of the armrests (Fig. 3).
Parts List (CR3811-S)
Part # Description Qty Part # Description Qty
 S - Top Ladder Section   Ratchet Strap 

S - Middle Ladder Section   Stabilizer Strap 2
 S - Bottom Ladder Section   Rope 
 Foot Platform    
 Seat Platform   Instruction Manual 
 Side Frame 2 
 
 Top Ladder Extension 2
HARDWARE PACK
 Platform Support 2   
 Footrest    3
 Armrest 2   4
 Left Shooting Rail Piece    2
 Right Shooting Rail Piece    4
 Main Shooting Rail Piece    4
 Support Bar - Ladder Piece  
 
 Support Bar - Tree Piece    4
 Seat Cushion    
 Shooting Rail Cover   Snap Pin 
    Seat Tension Bolt 
CR3811S
SPECS
Minimum/Maximum Tree Diameter Max. Weight Capacity (User and Equipment) Maximum Occupancy Tools Required for Assembly
9" min. and 20" max. at installation height
(i.e., seating platform height)
300 lbs/136 kg ONE (1) Adjustable Wrench - Qty 2 (Not included)