Instruction manual

ManualsBrandsBig Game Treestands ManualsCamping EquipmentCR3806-S

READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.

This Instruction Manual complies with the Treestand Manufacturers Association’s

TMS 04-Standard Practice for Treestand Instructions & TMS 02-Standard Test Method for Treestand Fall Arrest Systems

Ladder

Section

PART A

PART B

Ladder

Section

Ladder

Section

Snap

5/16" Delta Bolt

Support

Bar Tree Piece

Support Bar

Ladder Piece

Safety

Sleeve

Safety

Sleeve

ADJUSTABLE SUPPORT BAR ASSEMBLY FOR CR4850-S ONLY FIG. 1

STEP 1. Assemble adjustable support bars by sliding Part A into the Part B, Fig. 1.

NOTE: The snap pin will be used to set the desired length of the adjustable support bars.

STEP 2. Attach support bar to ladder using remaining bolts and wing nuts.

NOTE:

These gures relate to Step 5 of the Installation Instructions from page 86.

CONNECTING LADDER SECTIONS

WITH SAFETY SLEEVES

STEP 1. Place the safety sleeve over the top of the middle ladder

section.

STEP 2. Insert the middle ladder section into the top ladder section

so that the safety sleeve is on the outside of both ladder pieces.

STEP 3. Insert the snap pin through the predrilled holes of the

safety sleeves, top ladder section and middle ladder section

to connect all pieces together. See Fig. 2 below. NOTE: Be sure

that the predrilled hole of the safety sleeve is assembled to the

top of the assembly.

ADjUSTABLE SUPPORT BAR

STEP 1. Assemble support bar by sliding tree piece into the

ladder piece. NOTE: The delta bolt will be used to set the

desired length of the support bar.

STEP 2. Attach support bar to ladder using remaining bolts

and wing nuts.

NOTE: These gures relate to Step 5 of the Installation

Instructions from page 86.

ADJUSTABLE SUPPORT BARS

FIG 2

Wrap snap pin closure around

front of tubing and secure

over end of pin.

Installed and

in the closed

position