Instruction manual

88
READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.
This Instruction Manual complies with the Treestand Manufacturers Association’s
TMS 04-Standard Practice for Treestand Instructions & TMS 02-Standard Test Method for Treestand Fall Arrest Systems
WARNING! The two (2) stabilizer straps must be attached and tightened prior to climbing
to attach the platform(s) ratchet strap(s). Additionally, the adjustable support bar(s) and the
adjustable support bar(s) rope must be installed (where included) prior to climbing to install the
platform(s) ratchet(s). Failure to follow these instructions may result in serious injury or death!
WARNING! Prior to climbing, make sure that all the ladders sections are rmly connected
with the proper hardware (snap pins) in place. Make sure none of the sections have become
separated. If they are, do not climb the ladder. With the help of two other adults, lower the stand
back down to the ground and reattach the ladder rungs and reinstall the hardware in the manner
previously described. Failure to follow these instructions may result in serious injury or death!
WARNING! Prior to attempting to climb a ladder stand for the rst time, make certain the feet
of the bottom rung ladder section are rmly planted on solid, level ground. If they are not rmly
planted on level ground, DO NOT climb the ladder. With the help of two (2) other adults, lower
the stand and nd a suitable location to safely install the ladder stand. Failure to follow these
instructions may result in serious injury or death!
WARNING! Before attempting to climb the ladderstand, bounce on the bottom ladder
section to set the ladder into the ground before attempting to climb the ladderstand. Once the
ladderstand has been set, re-check the stabilizer straps, making sure they are tight and the
adjustable support bar is level and rmly, and tightly installed. Failure to follow this warning may
result in serious injury or death!
WARNING! Always lean forward while climbing and securely attach your full-body fall arrest
harness tree belt to the tree prior to securing the platform to the tree and stepping onto the
platform. Failure to follow this warning may result in serious injury or death!
STEP 7. CRITICAL STEP! After installing the adjustable support bar and stabilizer straps, it is
now time to attach the RATCHET STRAP(S) to the top section of your ladderstand. Ratchets are
attached at the contact point from the stand to the tree. Hook one end of the ratchet onto the
rear frame support, near the bark biters, wrap around tree trunk, and connect to opposite side.
Carefully tighten the VITAL RATCHET STRAP securely. (see Fig. 5, page 87) NOTE: TWO (2) VITAL
RATCHET STRAPS ARE INCLUDED AND NECESSARY FOR SOME MODELS. ALWAYS USE ALL
PARTS REQUIRED.
WARNING! When climbing to secure the ratchet strap(s) on the platform(s), it is important
to lean forward when climbing to keep the stand centered and secure to the tree trunk. DO NOT
lean backwards when climbing. Failure to follow these instructions may result in serious injury
or death!
WARNING! When climbing, always maintain three points of contact as you ascend (climb
up) and while descending (climb down). Failure to maintain three points of contact puts the user
at serious risk of bodily injury. Failure to follow these instructions may result in serious injury or
death!
WARNING! The platform ratchet strap(s), stabilizer straps and adjustable support bar(s)
have all been included with your new ladderstand to ensure its solid attachment to the tree. All
three of these safety devices must be installed as outlined in this Instruction Manual. Failure to
install these safety devices as outlined in this Instruction Manual may result in serious injury or
death! NOTE: No support bar is included or required for CR5020-S.