Instruction manual

READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.

This Instruction Manual complies with the Treestand Manufacturers Association’s

TMS 04-Standard Practice for Treestand Instructions & TMS 02-Standard Test Method for Treestand Fall Arrest Systems

STEP 6. When the ladderstand is level and the adjustable support bar is secure, untie the

stabilizer straps from the ladder section. Criss-cross stabilizer straps behind the tree trunk

pulling them snug. Then, secure each stabilizer strap by tying several rm knots around a middle

section ladder rung. NOTE: Tie the stabilizer straps as high as you can reach while standing safely

on the ground. (Fig. 4)

FIGURE 3

FIGURE 4 FIGURE 5

Raising the Ladderstand Into Installation Position

Ratchet Strap

Stabilizer Strap

Note: Typical Installation. Note some models require two (2) ratchet straps.