Instruction manual
60
Accessorize at: www.BigGameTreestands.com
™
CR4802S THE BIG BUDDY
®
CR4602S /
CR4802S SPECS
Min. Tree Diameter • 9" at installation height (i.e., seating platform height)
# Person(s) • TWO (2)
Max. Weight Capacity (User(s) and Equipment) • 500 lbs/227 kg
TOOLS REQUIRED FOR ASSEMBLY Adjustable Wrench - Qty 2
To activate your product's warranty, a registration card can be found on page 98 and must be
completed and returned to the manufacturer within 30 days of purchase. Be sure to keep a copy of
this for your records.
WARNING! Read the
WARNINGS and FULLBODY FALL ARREST HARNESS USAGE INSTRUCTIONS &
WARNINGS on pages 3-15 prior to assembly of this product! Failure to follow the
instructions on this page and pages 3-15 may result in serious injury or death!
WARNING! DO NOT over tighten the hardware. Over tightening can lead to structural
damage and may negatively aect the performance of your stand. Failure to follow these
instructions may result in serious injury or death!
Refer to pages 84-91, Field Installation-Ladderstands, for installation instructions.
NOTE: Steps 1-7 require you to temporarily nger tighten nuts to ensure proper alignment. All
bolts should be installed from the inside with nylock nuts on the outside.
Attach the foot platform to the upper holes of the top ladder section using (2) 5/16'' x 2
1/2'' hex bolts [G] and (2) 5/16'' nylock nuts to secure. (Fig. 1)
Next, attach the under support gussets to the foot platform using (2) 1/4" X 1 3/4" hex
bolts [C] and (2) 1/4" nylock nuts. Then, connect the under support gussets to the top ladder
section using (2) 1/4'' x 2'' hex bolts [D] and (2) 1/4'' nylock nuts. (Fig. 1)
Secure the side seat supports to the foot platform using (4) 5/16" X 2 1/2" hex bolts [G]
and (4) 5/16" nylock nuts. (Fig. 2)
Attach the seat gussets to the side seat supports using (2) 1/4" X 2 1/4" hex bolts [E] and
(2) 1/4" nylock nuts. Then, attach the seat gussets to the foot platform using (2) 1/4'' x 1 1/4'' hex
bolts [A] and (2) 1/4'' nylock nuts. (Fig. 2)
Attach the front of the seat assembly to the side seat supports using (2) 1/4" X 2" hex
bolts [D] and (2) 1/4" nylock nuts. Then, secure the rear of the seat assembly to the side seat
supports using (4) 1/4" X 1 1/2" hex bolts [B] and (4) 1/4" nylock nuts. (Fig. 3)
Using (2) 1/4'' x 1 1/2'' hex bolts [B], (2) nylon washers and (2) 1/4'' nylock nuts attach the
left and right shooting rail pieces to the side seat supports. (Fig. 4)
Finish assembly of the shooting rail by inserting the shooting rail main piece into the
left and right shooting rail pieces using (2) 5/16'' x 1 1/4'' hex bolts [F] and (2) 5/16'' nylock nuts
to secure. (Fig. 5)
Attach the shooting rail cover to the shooting rail using velcro to secure. (Fig. 5)
You are now ready to install your ladderstand. Refer to pages 84-91, Field Installation-
Ladderstands, for installation instructions.