PR-W3PI
INTRODUCTION Thank you for purchasing the PR-W3PI. Your new Power Distribution Unit (PDU) by Big Dog Power provides filtered AC power to your equipment. 3 individually controlled outlets provide up to 2380 Joules of surge Protection. Wi-Fi and Wired LAN connections give flexibility with placement and network connectivity. The built in Self-Healing functions of the PR-W3PI will keep your network connected equipment going by automatically rebooting and maintaining the equipment.
LED Indicators “G” or Ground “P” or Power “N” or Network Outlet Status On: PDU is grounded properly Off: PDU is not grounded Blue: Good / Protected and Clean power Red: Bad, No Protection Blinking Red: No Network Connection Solid Blue: Good Network Connection Rapid Blinking Red: PDU failure requires reboot or reset On: Outlet is On Off: Outlet is Off INSTALLATION Surface Mount Step 1) Use the included screws to attach surface mount ears to PDU a) Surface mount ears may be attached at 0°, 90°, 180°, and 27
Wi-Fi Setup If using the Wi-Fi connection, follow these instructions Step 1) Plug in the included power cable to the PDU and to the AC mains outlet on the wall. a) Wait approximately 15-30 seconds, the power button will begin to flash. Step 2) Scan for Wi-Fi on your Wi-Fi enabled device with a web browser Step 3) Connect to the Wi-Fi SSID of the PDU a) The SSID of the PDU will be “Metra-xxxxxxxxxxxx” where the “x” are the MAC address or device ID of the PDU.
Read and observe the following safety points at all times. Notice For indoor use only. Internal components are not sealed from the environment. The device can only be used in a fixed location such as a telecommunication centre, or a dedicated computer room. When you install the device, ensure that the protective earthing connection of the socket-outlet is verified by a skilled person. Suitable for installation in Information Technology Rooms to power ITE equipment such as Monitors, Computers, Etc.
Warning – No user-serviceable parts inside If the PDU is not operating properly, do not remove any part of the unit (cover, etc.) for repair. Unplug the unit and consult the warranty section of the owner’s manual. Caution – Exposure to heat Do not expose the PDU to direct sunlight or place it near wall heaters, space heaters, or in an enclosed space prone to temperature increase. Do not use the device in a confined, poorly-ventilated location; this can overheat the unit, possibly even causing a fire.
FCC Part15C+RSS247 To assure continued FCC compliance: 1. Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. 2. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
© Copyright 2022 Ethereal Home Theater, LLC. The information contained herein is subject to change without notice. This document contains proprietary information protected by copyright law. No part of this document may be photocopied or reproduced without prior written consent. metrahometheater.com metraav.com MAVBase.