Product Manual

WWW.BIGASSFANS.COM © 2015 DELTA T LLC ALL RIGHTS RESERVED.
2
PARTS AND HARDWARE
You will only receive the hardware that will be installed with your selected mounting method. If you are mounting
the fan to a wall, column, metal or wood superstructure, or concrete ceiling, some hardware used to secure the
fan is installer-supplied. Big Ass Fans cannot provide specific installation details because of the wide variability of
mounting surfaces, conditions, and fastening methods. Consult a structural engineer to determine the required
hardware. Note: Drawings below are not to scale.
Parts
1. Optional. Pedestals are only included if ordered. Up to two (2) pedestals can be installed on Yellow Jacket.
2. Optional. Wall/Column mount parts and hardware are only included if ordered.
3. Optional. Yoke mount parts and hardware are only included if ordered. Square washers are only used if mounting the fan to angle irons.
4. Optional. The remotely mounted speed control and cable are only included if ordered.
3”
(7.6 cm)
3”
(7.6 cm)
Ø 9/16”
(1.4 cm)
Thickness:
1/4” (6 mm)
Square Washer
Fan Cage & Housing Portable Base with Wheels
Pedestal
1
Remotely Mounted
Speed Control
4
Yoke Mount
3
Wall/Column Mount Supports
& Yoke Attachment Brackets
2
(4) Guy Wire (4) Gripple
®
(8) Wire Rope Clip
Hardware
(8) 3/8” Flat Washer (4) 3/8-16 Nylock Nut (4) 3/8-16 x 1” Hex Bolt
Wheel
Hardware
Base
Hardware
(2) 1/2-13 Hex Nut (2) 1/2-13 x 3-1/2” Hex Bolt