Product Manual

Installing the remotely mounted speed control

Ensure power is disconnected from the fan prior to installing the remotely mounted speed control. Note: For

convenience, wiring should be performed when mounting the fan.

1. Mount the remotely mounted speed control on a wall or column using the four (4) provided mounting screws.

Select a mounting location that is 50 ft or less from the fan and from which the fan is visible. The mounting

location should also be readily accessible, free from vibration, and an adequate distance from foreign objects or

moving equipment. Remove the four (4) screws on the front, and then remove the cover. Save the cover, which

will be switched with the cover on the remotely mounted speed control.

2. On the fan speed control (located on fan), remove the four (4) screws retaining the

cover (with knob). Set aside the cover (with knob), which will be attached to the

remotely mounted speed control.

3. Remove the rubber grommet from the back of the fan speed control box (located

on the fan) to expose an empty knockout. Wire the loose end of the provided cable

(attached to remotely mounted fan control) to the fan-mounted fan speed control

through the empty knockout. Refer to the wiring diagram on the following page.

4. Replace the cover with the ﬂat cover previously attached to the remotely mounted

speed control. Test fan operation. See Fan Speed Control Operation on the

previous page for operating instructions.

REMOTELY MOUNTED SPEED CONTROL

WARNING: Disconnect power to the fan prior to wiring the remotely mounted speed control.

The remotely mounted speed control is an optional accessory used to operate a fan that is mounted in an

inaccessible location. Fifteen (15) feet of cable is provided with the remotely mounted speed control; however, the

control can be mounted up to 50 ft from the location of the fan using installer-supplied cable.

For operating instructions, see Fan Speed Control Operation on the previous page.

Remotely mounted speed control dimensions

Note: Drawings below are not to scale.

Remotely Mounted Speed Control

Mounting Holes

(Rear View)

Remotely Mounted Speed Control

(Front View)

3.25” (8.3 cm)

3.1” (8 cm)

2.8” (7 cm)

2” (5 cm)