Product Manual

FAN SPEED CONTROL OPERATION

CAUTION: The fan may begin to operate upon connection to power source. Do not plug in the fan until it

is fully assembled and in an acceptable upright position.

Starting, stopping, and speed control

ATTENTION

Ensure the position locking pin is secure in the locking plate prior to fan operation.

The speed control knob is located on the side of the fan, and turns the fan on/o and controls fan speed. Note: If

you purchased the remotely mounted speed control, see Remotely Mounted Speed Control on the following page

for installation instructions before operating the fan. Both the fan-mounted speed control and remotely mounted

speed control are operated the same.

To start the fan, turn the speed control knob to position 1. To stop the fan, turn the knob to the OFF position. Note:

There is a 10 second delay after starting or stopping the fan.

To adjust fan speed, rotate the knob to the desired speed setting (1 to 10).

Speed

Control

Note: Fan setup may dier from the illustration.

Speed Control