Product Manual

ELECTRICAL INSTALLATION

WARNING: To reduce the risk of electric shock, wiring should be performed by a qualiﬁed electrician! Incorrect

assembly can cause electric shock or damage the motor and the controller! Hazard of electrical shock!

WARNING: The installation and usage of a Big Ass Fan must be in accordance with the requirements speciﬁed

in this installation manual and with any additional requirements set forth by the national electric code (NEC)

and all local codes. Code compliance is ultimately YOUR responsibility! Failure to comply with these codes

could result in personal injury or property damage.

WARNING: Exercise caution and common sense when powering the fan. Do not connect the fan to a damaged

or hazardous power source. Do not attempt to resolve electrical malfunctions or failures on your own. Contact

Big Ass Fans if you have any questions regarding the electrical installation of this fan.

WARNING: Do not operate this fan from an ungrounded receptacle or use any device on the power cord that

can defeat proper earth ground such as a plug adapter.

CAUTION: Do not operate the fan with a damaged power cord or plug. Return fan to authorized service facility

for examination or repair.

CAUTION: Do not run power cord under carpeting. Do not cover cord with throw rugs, runners, or similar

coverings. Do not route cord under furniture or appliances. Place cord away from trac area and where it will

not be tripped over.

ATTENTION: If installing the fan in the United States, the fan must be installed per the following National Fire

Protection Association (NFPA) guidelines:

• The fan must be centered approximately between four adjacent sprinklers.

• The vertical distance from the fan to the sprinkler deﬂector must be at least 3 ft (91.4 cm).

Power requirements

Motor hp (kW)

0.5 (0.37)

Minimum required supply circuit size

20 A @ 100–125 V, 1 Ф

15 A @ 200–240 V, 1 Ф

Current

7.6–9.8 A @ 100–125 VAC, 1 Ф

5.0–5.6 A @ 200–240 VAC, 1 Ф