Product Manual

WWW.BIGASSFANS.COM © 2015 DELTA T LLC ALL RIGHTS RESERVED.
21
5. Attach beam clamp
Attach the beam clamp to the I-beam. The guy wire should be at a
30
o
–45
o
angle from the roof to the Yellow Jacket
®
extension tube.
Place the beam clamp accordingly. Fully tighten the set screw to
secure the clamp.
Fasten the small eyebolt and nut onto the beam clamp. The nut will
be on the outside of the beam clamp.
Loop the crimped end of the guy wire into the locking carabiner and
secure to the eyebolt. Securely tighten the carabiner.
Guy Wire Hardware:
a. (4) 1/4” Beam Clamp
b. (4) 1/4-20 x 1” Eyebolt
c. (4) 1/4-20 Hex Nut
d. (4) Locking Carabiner
e. (4) Guy Wire
Top View
Extension Tube
Guy Wire
Clip
6. Route guy wire through Gripple
®
Route the guy wire through the Gripple, the guy wire clip at the bottom of the extension tube, and back through
the Gripple. Do not tighten the Gripple until the remaining guy wires have been installed.
Note: To back the guy wire out of the Gripple, insert a 1/16 (1.5 mm) Allen wrench into the small hole on the Gripple.
Gripple
Beam Clamp
a
c
b
d
e